All of the above are two bar sets though three might be an idea to help distribute the strain as much as possible I guess. All to fit the old shape pre-2008 Berlingo and the later First - I believe all of these have the same mountings. Will get New mot prior to sale, 3 months left on existing. Will also get a replacement sliding door external trim to replace.

Insulated with 25mm celotex (earthwool where celotex not possible) with sound deadening panels, covered with silver foil insulation, taped on joints to create vapour barrier.We will use reasonable endeavours to provide you with a proof of delivery for the Consignment on request. We may charge for providing a proof of delivery, which is requested more than 14 Working Days after delivery of the Consignment concerned. Though I have the Modutop I don't like putting any significant load on its roof bars as it would seem like doing so might increase the chance of a Modutop leak and that seems very much worth avoiding. Besides they have a low weight rating. As I was buying them second hand my non scientific test of their integrity was to stand on them (before fitting to car) Lpg gas set up with fixed regulator and isolation manifold supplying a 2 burner hob and smev built in oven and grill in the kitchen, External water inlet with 30psi shureflow water pump and accumulator. Hot and cold supply to kitchen sink via mixer tap.

but I don't like the welded on load stops - will make getting stuff on harder. And the oval tubes as pictured earlier look more than strong enough anyway. This Vivaro has raised mounting points with threadless holes in them, 3 pairs of mounts at the rear points, and 1 single mount at the front above the roof hump. Each kit is supplied with clips to add an M6 thread to the holes, and the legs are fitted to these. Rhino Delta Roof Bar System Fitting Instructions - Vivaro Up to 2014Completely off grid living available with 270w solar, 20A solar charger, 220A batteries (2x 110A) plus Split charge relay. As for securing a roof box, it would depend on the internal design of the one in question but I think most of them have metal bars which offer some degree of flexibility with regards to where the mounting points locate.